Inhaltsverzeichnis
Werbung
en
Installing the appliance
Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e.g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use
a suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to an electric cooker.
30 cm to an oil or solid fuel cooker.
24
Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current
via a correctly installed earthed socket.
The socket must be fused with a 10 A to
16 A fuse.
If the appliance is to be operated
in a non European country, check on the
rating plate whether the indicated voltage
and current type correspond to the values
of your mains supply. The rating plate
is situated in the bottom left hand side of
the appliance. The mains connection
cable may be replaced by an electrician
only.
Warning
!
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).
Werbung
Inhaltsverzeichnis
