Inhaltsverzeichnis
Werbung
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for
the first time, clean the interior of the
appliance (see chapter Cleaning).
The socket should be freely accessible.
Connect the appliance only to
220 240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with a 10 A
to 16 A fuse.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the bottom
left hand side of the appliance. The power
cord may be replaced by a technician
only.
Warning
!
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).
Switching on
the appliance
Switch on the appliance with the main
switch. Fig. 1/5
The temperature display flashes, Fig. 2/4,
until the appliance has reached the set
temperature.
Interior light in refrigerator compartment
is switched on when the door is open.
Operating tips
While the refrigerating unit is running,
beads of water or hoarfrost form at
the back of the refrigerator compartment.
This is quite normal. It is not necessary to
scrape off the frost or wipe off the beads
of water. The rear panel defrosts
automatically. The condensation flows
into the evaporation area of the appliance
via the condensation channels and
the drainage hole.
en
23
Werbung
Inhaltsverzeichnis
