Inhaltsverzeichnis
Werbung
en
Fault
Appliance is not cooling,
temperature display
lamps and interior light
are lit.
The interior light is not
The interior light is not
functioning.
functioning.
Temperature display
lights are flashing.
Fig. 2/4
The temperature in the
cool fresh" compart
ment is too cold or too
warm.
Customer service
Please check your telephone book or the
customer service list for your nearest
customer service facility. When
contacting customer service, please
ALWAYS quote the product number
(E number) and production number
(FD number) of your appliance.
32
Possible cause
Showroom mode is switched on.
The LED light is defective.
Door was open too long.
Light switches off after
approx. 10 min.
Appliance door opened frequently.
A lot of food was placed in the
freezer.
The fixed setting has been set too
high or too low (e.g. if there is frost
in the cool fresh" compartment)
Remedial action
Hold down Alarm button, Fig. 2/1,
for 10 seconds until an
acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.
See chapter Light (LED)" section.
When the door is closed and
opened, the light is on again.
Do not open the door unnecessarily.
Switch on Super cooling before
placing food in the freezer.
The temperature in the cool fresh
compartment can be changed to be
2 steps warmer and/or colder. If the
bargraph is set to 4, the cool fresh
compartment has a temperature of
almost 0 °C.
The numbers on the bargraph do
not correspond to the cool fresh
compartment temperatures.
Step 2 - coldest setting
Step 8 - warmest setting
Press button for 3 seconds
until a beeping signal sounds,
the display 4 flickers. Fig. 2/2
Change the setting with button 3.
After one minute, the set
temperature is stored.
These numbers can be found on the
rating plate. Fig. e
To prevent unnecessary call outs, please
assist customer service by quoting the
product and production numbers. This
will save you additional costs.
Werbung
Inhaltsverzeichnis
