Information Concerning Disposal; Scope Of Delivery; Installing The Appliance - Siemens KA62DV78 Gebrauchs- Und Montageanleitung

Information concerning
disposal
x Disposal of packaging
The packaging protects your appliance from damage
during transit. All utilised materials are environmentally
safe and recyclable. Please help us by disposing of
the packaging in an environmentally friendly manner.
Please ask your dealer or inquire at your local
authority about current means of disposal.
x Disposal of your old appliance
Old appliances are not worthless rubbish! Valuable
raw materials can be reclaimed by recycling old
appliances.
This appliance has been identified in accordance
with the European directive 2002/96/EC
on Waste Electrical and Electronic Equipment
(WEEE).
The directive specifies the framework for an
EU‐wide valid return and recycling of old
appliances.
! Warning
Redundant appliances:
1. Pull out the mains plug.
2. Cut off the power cord and discard with the mains
plug.
3. Do not remove the shelves and containers. Leaving
them intact makes it more difficult for children to
climb in!
4. Never let children play with a worn out appliance.
Risk of asphyxiation!
Refrigerators contain refrigerants and the insulation
contains gases. Refrigerant and gases must be
disposed of properly. Ensure that tubing of the
refrigerant circuit is not damaged prior to proper
disposal.

Scope of delivery

After unpacking all parts, check for any damage in
transit.
If you have any complaints, please contact the dealer
from whom you purchased the appliance or our
customer service.
The delivery consists of the following parts:
Free‐standing appliance
n
Interior fittings (depending on model)
n
Operating instructions
n
Installation manual
n
Customer service booklet
n
Warranty enclosure
n
Information on the energy consumption and noises
n
Bag containing installation materials.
n

Installing the appliance

Transporting
The appliance is heavy and must be secured during
transportation and installation.
Because of the weight/dimensions of the appliance
and to minimise the risk of injuries and damage to the
appliance at least two persons are necessary to
set‐up the appliance securely.
Installation location
Install the appliance in a dry, well ventilated room. The
installation location should neither be exposed to
direct sunlight nor near a heat source, e. g. a cooker,
radiator, etc. If installation next to a heat source is
unavoidable, use a suitable insulating plate or observe
the following minimum distances to a heat source:
3 cm to electric or gas cookers.
n
30 cm to an oil or solid‐fuel cooker.
n
If installing the appliance next to another refrigerator
or freezer, there must be a minimum gap of 25 mm
between the appliances in order to prevent
condensation.
If a panel or cupboard is installed above the
appliance, ensure that a gap of 30 mm is left so that
the appliance can be pulled out of the recess if
required.
The air heated on the rear side of the appliance must
be allowed to escape unhindered.
en
33