Setting-Up Operation; Using The Radio-Controlled Socket - Silvercrest IAN 303937 Bedienungs- Und Sicherheitshinweise

Setting up / Setting-up operation
button (A, B, C or D) on the re-
2
mote control. The LED operating
status display
continuously. You can now use the
remote control to switch a con-
nected device on or off using.
5. Repeat this process with the other
wireless sockets.
Note: You can use one channel
ON / OFF button
several remote-controlled sockets
at once. You can further train six
remote controls successively and
use these for a single receiver. This
means you can switch one appliance
on and off from up to six different
places. In this case, synchronise
every remote-controlled socket with
the channel of the remote control.
Note: The codes for the remote
control will also remain stored
when changing the batteries.
Note: The codes will remain
permanently stored when discon-
necting the remote-controlled
socket from the power supply.
Note: Avoid interference: Ensure
the various remote-controlled sockets
are approx. 50 cm apart.
Note: The LED operating status dis-
play
indicates if the remote-con-
5
trolled socket is in ON / OFF mode.
Deleting a code:
To delete a code, first repeat steps
1–3.
With the LED operating display
flashing, press the desired OFF
button of the channel ON/ OFF
30 GB/MT
will now light
5
to switch
2
5
button (A, B, C or D) you wish
2
to delete on the remote control.
The LED operating status display
will flash rapidly for approx. 2 sec-
onds to confirm deletion.
It will then flash slowly again for
approx. 30 seconds and a new
code entered.
Deleting all codes:
To delete all codes, first repeats
steps 1–3.
Then with the LED operating status
display flashing, press the
5
ALL-OFF button
control. The LED operating status
display will flash rapidly for
5
approx. 2 seconds to confirm dele-
tion, then go out.

Setting-up operation

Q
U sing the radio-
Q
controlled socket (fig. B)
1. Put the radio-controlled socket into
any shuttered socket and connect
the appliance you want to operate.
2. Switch the electrical appliance on.
The radio-controlled socket can
only perform its switching function
when the device to be controlled is
switched on.
ATTENTION! FIRE HAZARD!
Do not attach any appliances which
could cause fires or other damaged
if left unattended when switched
on. The maximum load of every
radio-controlled socket is approx.
5
on the remote
3