Smartchuck Tm - Velp Scientifica OHS 200 ADVANCE F20100480 Bedienungsanleitung




Check Locking
Ring



Reset

Parameters

Update

Software
Counter

Ermes

TM
8. SmartChuck
This new mechanism (F) allows to change the stirring shaft with one hand.

When instrument is off, hold the stirring shaft with one hand.

From work position

The main screen displays

Pull Locking Ring down

Open the chuck.

Remove the shaft.

Introduce a new stirring shaft and place it in the operating position.

Ensure the stirring shaft is centered as best as possible. Then close the chuck.

Push Locking Ring up

The yellow upper bar on the display becomes blue and the OHS is ready to be used.
Alignment sensitivity 0.1°C.
It allows to control the right functioning of Smart Chuck system.
Figure 20
Enter in the menu.
Figure 12. Check Locking Ring
Follow instructions described in the screen.
Once the operation is performed, Check becomes white and a blue bar appears on the left.
It allows to return to default value for all functions.
Click with the speed control knob (C) to reset parameters.
It allows to update the device with a new software version.
Software version, dedicated program to be installed in the PC, and software installation guide have to be
requested by e-mail to service@velp.it.
It allows to see the number of instrument working hours.
It allows to connect the instrument to Ermes Cloud.
(Figure ), turn Locking Ring 90° to the left
Figure 22.
(Figure 25).
(Figure 26) and turn it 90° to the right.
is visualized.
Figure 11.
performed
(Figure ).
16
Check Locking Ring
Figure 13. Locking Ring open