Specifications; General Power Tool Safety Warnings - Makita DTW450 Betriebsanleitung

ENGLISH (Original instructions)
1. Red part
2. Button
3. Battery cartridge
4. Indicator lamps
5. Check button
6. Switch trigger
7. Lamp
8. Lamp switch
9. Impact socket

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
Max. fastening torque
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Intended use
The tool is intended for fastening bolts and nuts.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
4
Explanation of general view
10. Square drive
11. Ring spring
12. O-ring
13. Pin
14. Hole
15. Detent pin
16. Groove
17. Screw
18. Hook
Model
Standard bolt
High tensile bolt
Square drive
-1
)
Net weight
BL1815N/BL1820/BL1820B/BL1830/BL1830B/BL1840/BL1840B/BL1850/
BL1850B/BL1860B
DC18RC/DC18RD/DC18RE/DC18SD/DC18SE/DC18SF
Save all warnings and
ENE036-1
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
GEA010-2
(cordless) power tool.
CORDLESS IMPACT WRENCH
SAFETY WARNINGS
1. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
fastener may contact hidden wiring. Fasteners
contacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator an
electric shock.
19. Standrad bolt
20. Fastening torque
21. Proper fastening torque
22. Fastening time (S)
23. High tensile bolt
24. Limit mark
25. Brush holder cap
26. Screwdriver
DTW450
M12 - M22
M12 - M16
12.7 mm
1,600
2,200
440 N·m
266 mm
3.1 - 3.4 kg
D.C.18 V
GEB138-1