Check The Presence And Efficiency Of The Protections And Safety Devices; Check The Functioning Of The Stop Push-Button; Start Up Of The Machine; Use Of The Machine - Berkel BM +42F Gebrauchs- Und Wartungshandbuch

5.2 - Check the presence and efficiency of the protections and safety
devices
1 - Product exit opening.
Check that the diameter of the holes of the product exit opening is smaller than 8
mm.
If it is not, the user must install an adequate protection on the opening.
2 - Hands protection
The hopper must be equipped with hand protection.
3 - Stainless steel hopper.
The stainless steel hopper must be fixed correctly to the structure.
4 - Protective cover for electric parts.
Check the presence, the integrity and the correct fixing of the electric parts
protective cover.

5.3 - Check the functioning of the stop push-button

(fig. 5.3.1)
Connect the machine to the power supply and
make it work, then press the stop push-button "2"
Fig. 5.3.1. The machine has to stop.
1 2 3
Fig. 5.3.1
5.4 - Start up of the machine (fig. 5.3.1)
To start the machine, connect the plug in the
power supply outlet and press push-button "on"
"1" Fig. 5.3.1 and the machine starts.
1 2
5.5 - Stopping the machine (fig. 5.3.1)
To stop the machine, press stop push-button , "2" Fig. 5.3.1 and the machine
stops.

6 - Use of the machine

6.1 - Prescriptions

WARNINGS!
Only the authorized personnel can intervene on the machine.
Before using the machine, the operator must check that all the protections and
safety devices are correctly installed and working. Otherwise stop the machine and
call the person in charge of the maintenance.
The shape and volume of the product must be adequate to enter in the feeding
opening, it must be pushed inside by means of the pestle NEVER DO IT WITH
YOUR HANDS.
6.2 - Installation of the exit opening and pestle.
The machine can be equipped with three kind of cut:
A - Enterprise or normal
B - Half UNGER
C - Total UNGER
16