Switching Off; Care And Maintenance - Hilti GDG 6-A22 Original Bedienungsanleitung

2. Slide the on/off switch forward.
▶ The motor runs.
3. Lock the on/off switch.
6.2 Types of work 3
1. Switch the tool on. → page 21
2. By turning the adjusting knob for speed, set a speed that is suitable for the accessory tool and the
planned use.
3. Use only the intended working face of the accessory tool. Example: Never try to use the flat side of an
abrasive cut-off disc for grinding. Abrasive cut-off discs are intended for cutting at their peripheral edge.
4. Secure the workpiece. Never try work with a small workpiece held in one hand and the die grinder held
in the other. Always hold the die grinder with both hands on the grips provided.
5. Guide the die grinder to the workpiece. Apply moderate pressure and do not press the accessory tool
into the material.
6.3

Switching off

▶ Press the rear section of the on/off switch.
▶ The on/off switch jumps into the off position and the motor stops.
7

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group.
7.1 Changing clamping nut
ATTENTION
Risk of damage to the collet if the clamping nut is tightened on an empty collet.
▶ Never tighten the clamping nut without an accessory tool inserted in the collet.
1. Hold the spindle with the small wrench and use the large wrench to loosen the clamping nut.
2. If applicable, pull the accessory tool out of the collet.
3. Unscrew the clamping nut with collet from the die grinder.
22 English
4
2276758
*2276758*