Preparing Food; Crushing Ice - Silvercrest SSM 250 B1 Bedienungsanleitung

Preparing food

WARNING! Risk of material
damage!
Thick or firm peels, (e.g. of citrus fruits, pine-
apple), stems and pips of stone fruits (e.g.
cherries, peaches, apricots) must be removed
before blending.
• Rinse or wash the fruits.
• Cut the fruit into rough pieces (approx.
3-4 cm edge length).
• Please use a sufficient amount of liquid
(mineral water, fruit juice, milk, yoghurt).
We recommend a mixing ratio of 1:1.
Blending
CAUTION: depending on the hardness
and consistency of the ingredients in the
blender jug 6, do not fill it to the maximum;
otherwise the blade assembly 4 could be-
come clogged.
NOTES:
• If the smoothie is too thick, add a little
mineral water, fruit juice, milk or yo-
ghurt to suit your taste.
• You may achieve a more even consisten-
cy for the smoothie (e. g. when using
harder fruits), if you repeatedly interrupt
and restart the blending process (pulse
function: release and then press the mix
button 2 again).
• If there are still bit of food (e.g. fruit
cores) on the sealing ring 14, wipe it
down with kitchen roll in order to ensure
its sealing function.
1. Place the fruit pieces and other ingredi-
ents into the blender jug 6 as desired.
2. Figure C: stick the blender jug into the
preassembled blade assembly 4 from
the bottom. The marking 9 points to-
wards the opened lock 5. The locking
blades 10 on the blender jug engage
into the recess at the blade insert.
3. Turn the blender jug as far as it will go in
a clockwise direction, until the marking 9
points to the closed lock 5.
4. Connect the mains plug 7 with the wall
socket.
5. Figure A: pivot the blender jug with
the motor unit 1 into its maximum up-
ward position.
6. Press and hold the mix button 2. The
blending process is started.
7. Release the mix button 2 after approx.
10 - 20 seconds. The blending process
is thereby completed.
8. Figure B: pivot the blender jug with
the motor unit into its fully downwards
position.
9. Wait until the drink has collected in the
blender jug 6 .
10. Turn the blender jug anti-clockwise until
the marking 9 points to the opened
lock 5.
11. Pull the blender jug downwards to re-
lease it from the blade assembly 4. To
remove the large blender jug, first pivot
the motor unit slightly upwards.
12. If there are still rather large pieces of
fruit in the smoothie, repeat the blend-
ing process for a few seconds.
13. If necessary, close the blender jug with
the lid 11.
14. Clean the device with the cleaning
jug 8 as soon as possible after use.
15. Disconnect the mains plug 7 from the
wall socket.

Crushing ice

• Place a maximum of 50 g of ice cubes
per process into the blender jug.
• To crush ice, you should briefly interrupt
and restart the blending process several
times (pulse function: release blender
button 2 and press it again)
43
GB