Instar IN-8015 Bedienungsanleitung Seite 23

01 - Photosensor
02 - Lens
03 - Infrared LEDs
04 - PIR Detector
05 - Loudspeaker
06 - MicroSD Card Slot
07 - Microphone
08 - Power Connector
09 - WPS / Reset
10 - Alarm In/Out
11 - Antenna Connector
12 - Network Port
13 - Audio Output
14 - Status LED
15 - Mount
16 - Camera Label
4.3. Status LEDs
Status LED
Constant on
Slow Flashing
Fast Flashing
Off
Go to http://install.instar.com
Twilight switch for IR LEDs
Wide-angle (focal length: 4.3mm / field of view: ~ 90º dia.)
10 IR LEDs (nightvision @ 850nm)
Integrated passive infrared motion detector
Integrated loudspeaker
Slot for MicroSD/SDXC cards (max. 128GB - 16GB included)
For noise detection / audio rec. / two-way audio intercom
5V / 2A DC - Plug Ø : 1.35mm (in) / 3.5mm (out)
3 seconds for quick WiFi setup / 15-20 seconds for reset
Input for potential free external alarm sensors
Output (relay) can support max. 24V/1A
RP-SMA WiFi antenna connector (not for PoE version)
RJ45 LAN port / connector for Cat5e LAN cable or higher
3.5mm jack for earphone / active speaker
Red: power; blue: network status (both can be turned on/off)
Standard camera thread for included stand (1/4"-20 UNC)
P2P ID, LAN MAC address and serial number
Blue LED
Connected to WiFi
Connecting via WPS
N/A
LED is turned off, or camera
is not plugged into power
Red LED
N/A
Camera at work
Upgrading firmware
LED is turned off, or camera
is not plugged into power
6-EN