OPERATION
Sanding operation
Fig.10
CAUTION:
Never run the tool without the abrasive paper. You
•
may seriously damage the pad.
Do not block motor vent with your finger or hand.
•
Never force the tool. Excessive pressure may
•
decrease the sanding efficiency, damage the
abrasive paper or shorten tool life.
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. Keep the pad flush with the
workpiece and apply slight pressure on the tool.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Abrasive paper (with pre-punched holes)
•
Velcro type of abrasive paper (with pre-punched
•
holes)
Joint 25 (for connecting to vacuum cleaner)
•
Paper dust bag
•
Paper dust bag holder
•
or
attachments
Only use
accessory or
are
5