Safety Instructions - axing EoC 1-11 Betriebsanleitung

STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to correct the interference by
one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help
VCCI & CE...
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Herewith AXING AG declares that the marked products comply with the valid guidelines.
You can call up the complete EU declaration of conformity for download by entering the
article in the search field at www.axing.com.
WEEE Nr. DE26869279 | Electrical and electronic components must not be disposed of
as residual waste, it must be disposed of separately.

Safety instructions

 Do NOT use the device near water or in rooms with high humidity such as humid cellars or near swimming
pools.
 Do NOT use the device outdoors. All connections must be located inside a building.
 Keep the device away from moisture, dust or corrosive liquids.
 Do NOT install the device, use it or perform maintenance during a thunderstorm. There is a risk of electric
shock during thunderstorm.
 Connect ONLY appropriate accessories to the device.
 Use ONLY the supplied AC adapter.
 Make sure that all cables are connected to the correct port.
 Carefully lay the Ethernet, antenna and electric cables to ensure that nobody can step on or stumble over
them.
 Do NOT cover the ventilation slots of the device since insufficient air supply may result in damage to the
device.
 Do NOT place any objects on the device. Do not place objects filled with liquids such as vases on the device.
 Position the device in a place where NOBODY can step on it.
 In case of damage, interrupt the power supply immediately.
 Do NOT try to repair the device. This equipment should ONLY be serviced or repaired by qualified service
personnel. Contact your distributor for more information.
 Do NOT open the device.
 Prior dismounting, disconnect the electric, Ethernet and antenna cable from the device.
2020-01-08 | Technical improvements, changes in design, printing- and other errors expected. 3