Rehau RAUTOOL A-LIGHT2 KOMBI Bedienungsanleitung / Technische Information Seite 29

4. Insert fitting into pipe up to the stop. After a brief period, the fitting will sit
tightly in the pipe (memory effect).
Attention:
All sealing ribs must be covered. Until the memory effect sets in fully, the
fitting can fall out of the pipe! Make sure to seat the fitting in level position.
5. Rotate the compression unit in the direction of the operating switch
(activating compression function).
Fully insert the joint into the compression unit.
Attention:
Do not tilt. The tool must be applied across the entire surface and at a right
angle.
6. Start the compression process by pressing the operating switch and slide
the compression sleeve up to the fitting collar.
Attention!
Do not touch moving parts (risk of trapping fingers!)
The compression process can be interrupted at any time by releasing the
operating switch.
7. The tool comes equipped with a semi-automatic release valve. If the tool is
moved to its final position for a prolonged period or used again after arriving at
its final position, the tool will automatically return to its starting position.
Furthermore, the tool can be manually returned to its starting position if the
release valve is actuated (black button opposite the operating switch).
8. Completely compressed compression sleeve joint.
Processing at temperatures under -10 °C and over +45 °C may result in
damage to jointing components, to the tool and/or in personal
injury!
- Do not work below the minimum processing temperature of -10°C!
- At lower temperatures (below 0 °C) it is recommended that the
jointing components be stored in a warm environment before being
processed
29