Assembly Procedure - Rehau RAUTOOL A-LIGHT2 KOMBI Bedienungsanleitung / Technische Information

ASSEMBLY PROCEDURE

Compression sleeve
Failure to observe these instructions may result in damage to the join-
ting system, to the tool and in personal injury
1. Using pipe cutters, cut pipe to required length at right angles and without
leaving burrs.
Attention:
Keep your hand at a safe distance from the tool. Do not use saws, or similar!
2. Slide compression sleeve onto pipe.
Attention:
With metal compression sleeves, the inside taper must point towards the joint!
3a. Expansion using expanders:
Expand pipe, rotate 30°, and repeat.
The min. distance between expander head and compression sleeve must be
two compression sleeve lengths.
Do not tilt the pipe when expanding! Do not expand under bending stress!
3b. Expansion using expanding unit:
Rotate the expanding unit in the direction of the operating switch (activating
expanding function), expand pipe, rotate by 30° and repeat.
During this process observe a minimum distance (two compression sleeve
lengths) between the expansion head and compression sleeve
Do not tilt pipes during expansion!
Do not subject the pipe to bending stress during expansion!
3c. Expansion using expanding unit
Rotate the expanding unit in the direction of the operating switch (activating
expanding function), expand pipe, rotate by 30° and repeat.
During this process observe a minimum distance (two compression sleeve
lengths) between the expansion head and compression sleeve.
Do not tilt the pipe when expanding! Do not expand under bending
stress!
28