Driver Installation; Data Transfer; Dealing With Problems - Beurer EasyFit 2.0 Installation

ulsuhr
tor
saciones
metro
EasyFit 2.0
EasyFit 2.0
EASYFIT INSTALLATION
1. Place the CD-ROM supplied in the drive and
choose the CD drive in Windows Explorer or
on the desktop of your PC.
2. Double-click the "setup.exe" fi le to run it.
3. Choose your language and follow the instal-
lation instructions. Confi rm with "Next" or
"Install" as appropriate.
4. When you click "Finish", the software starts.
5. Enter your personal details under "New reg-
istration" in the EasyFit program and click
"Save" to confi rm.
Windows 2000:
5. If the "Required files" window appears, close
it with "Cancel".
6. Then double-click the file "DriverInstall.exe"
(see step 3). After a few seconds, installa-
tion is complete. Click "OK" in the installa-
tion window.
Windows XP / Vista:
5. If the "Found New Hardware Wizard" win-
dow appears, close it with "Cancel".
6. Then double-click the file "DriverInstall.exe"
(see step 3).
7. Depending on the settings of your PC, the
"Hardware installation" and/or "Software in-
stallation" may appear on the screen. These
refer to the Windows logo test. Ignore these
warnings and click "Continue installation" to
end the installation.

DRIVER INSTALLATION

Basic information:
Always use the same USB port on your PC
for data transfer.
itor from/to the PC every time you do a data
transfer.
ners connected to your PC via a USB
cable.
problems".
1. First, close any applications that may be
running.
2. Place the CD-ROM supplied in the drive and
choose the CD drive in Windows Explorer or
on the desktop of your PC.
3. Open "Vista Driver" respectively
Win2000 Driver" subfolder in the "Software"
folder.
4. Then connect the PC-Clip to the heart rate
monitor and after that connect the USB plug
to the PC. Be sure to connect the three pins
of the clip correctly to the three contacts on
the back of the heart rate monitor. The heart
rate monitor display now shows "PC Link".

DATA TRANSFER

1. Start EasyFit.
2. Go to the "Data Manager" menu and click
the "Transfer data" button.
3. Now connect the heart rate monitor to your
PC as described above. Stored data are
now transferred from the heart rate monitor
to the PC.

DEALING WITH PROBLEMS

Error message "Transmission failed":
Click "OK" in the message window and dis-
connect the USB cable from the PC. Start
data transfer again. As soon as the time
and date appear on the heart rate monitor,
connect the heart rate monitor to the PC.
Always remember to establish a new con-
nection between the heart rate monitor and
the PC for every data transfer.
If the driver has already been installed, the
"Find new hardware" wizard appears:
Use the same USB port for data transfer as
you used when installing the driver, or re-in-
stall the driver again (see "Driver installation")
for the desired USB port.
cardiofrequenzimetro
F F
E E
I I
EasyFit 2.0
GB
scan-
"XP