Saddle - Qwic PERFORMANCE serie Bedienungsanleitung

Saddle

Desired seat height
The seat height is defined as the distance between the seat
surface and pedal in the lowest position. The seat height
is properly adjusted when the knee is bent just a little
while you stand with your foot on the pedal (in the lower
position). Please do not hesitate to ask your dealer for
advice!
i
If you can put your feet flat on the ground,
your saddle is too low.
Seat height adjustment
For the Performance models the seat clamp is integrated
in the seat tube. Remove the rubber cover by pulling it
upwards as shown in the picture. Similar to the regular seat
clamp, the height of the seat can be adjusted by loosening
the Allen bolt with an Allen key. Adjust the seat pen to the
correct height and tighten the Allen bolt again.
Do not forget to tighten the bolts and
!
make sure that your seat is attached firmly
again after adjustments!
ADJUSTING THE BICYCLE
Please do not force the seatpost in case
!
the clamp is not fully released. This might
cause damage to the seatpost. Instead
loosen the seat clamp some more by
rotating the Allen bolt counterclockwise.
!
The safety marks should never be visible
when the seat is adjusted in height.
59