Qwic PERFORMANCE serie Bedienungsanleitung Seite 42

USB connection
The USB connection on the back of the display can be
used to provide power to devices such as smartphones
and navigation devices. It can also be used when the
system is off, if the battery is still on the bike.
Reset
Press 'POWER' and the '∆' button > for 10 seconds o reset
the display.
Error codes
Your bike has been equipped with a self-diagnosis tool to
find possible problems early. In case an error has been
reported by the system the maintenance symbol on the
display will be accompanied by an error code in the journey
data field (right bottom corner). The most occurring errors
can often be solved by yourself:
Storingscodes MD11, MD11 speed, MN380, MA11 speed
Code 48 - Speedsensor error
The speed is monitored by a small magnet on the rear
wheel and a sensor on the frame. Please check if the
magnet is still aligned with the sensor
42
Code 64, 66 or 67 - Battery voltage too low
Check if the battery is properly charged.
It is possible that other errors are detected in the system,
or that the above instructions do not help.
In this case, please contact your dealer.
Storingscodes RD11, RD11 speed
Code 64, 66 or 67: Battery voltage too low
Please check if the battery has enough power. Charge the
battery if neccessary
Code 116: Malfunction in brake sensor(signal)
Braking while starting up the console can cause an error.
Please restart the console.
Code 80 : High temperature
The system became to warm. Please let it cool down.
Contact the dealer in case of repetition.
It is possible that other errors are detected in the system,
or that the above instructions do not help.
In this case, please contact your dealer.
DISPLAY & CONTROLS