Ottobock 504 Ankle Support Gebrauchsanweisung Seite 10

4.1 Size Selection
1) Use a tape measure to make an "8" around the ankle and midfoot (size
chart).
2) Measure the ankle circumference above the lateral malleolus and the
midfoot circumference (metatarsus) to determine the overall circumfer­
ence.
3) Select the size of the support (see size chart).
4.2 Application
CAUTION
Incorrect or excessively tight application
Skin irritation due to overheating, local pressure points due to tight applic­
ation to the body
► Ensure that the product is applied properly and fits correctly.
► When in doubt, do not continue to use the product if skin irritation
occurs.
> The patient is sitting on the front edge of a chair.
1) Slip one loop of the support over the foot from the front (see fig. 1).
2) Pulling from the inner side, guide the support around the ankle and
under the foot from the inside (see fig. 2).
3) Pull the support over the arch and around the heel again (see fig. 3, see
fig. 4 and see fig. 5).
4) Pull the loop over the foot from the front (see fig. 6).
4.3 Cleaning
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
► Only clean the product with the approved cleaning agents.
Clean the support regularly:
1) Recommendation: Use a laundry bag or net.
2) Wash the support in warm water at 40 °C with standard mild detergent.
Do not use fabric softener. Rinse thoroughly.
3) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight,
stove or radiator).
5 Disposal
Dispose of the product in accordance with national regulations.
10