SFA 3.4 Installationsanleitung Seite 13

13) Maintenance:
Before any intervention, disconnect the power
To check the status of your engine: fig. 12.
- Unscrew the cover screw
- Lift the cover
- Place a key in the motor shaft and turn it manually:
* If you can run this part of the engine, then open your tank and remove
the foreign body.
If nothing is blocking the turbine, consult an authorized repairman.
Warning !!!
This shredder is equipped with a thermal protection system, disconnect
the power supply to the unit for two hours to disarm security after
overheating.
14) Malfunction, causes, remedies:
Some mills operating anomalies have minor causes. To help diagnose,
refer to the table below.
Anomaly Reasons
- The connected fixtures
The unit restarts leaking.
intermittently. - The check valve is
leaking.
The motor runs - The vent cover is
correctly but the clogged.
water goes down - The drain is blocked.
slowly.
- The height or length of
The motor rotates discharge is too great or
but does not stop too many elbows.
or runs very long. - The pump is clogged
background.
- Device not connected.
The engine does - Faulty socket.
not start. - Problem motor or
timer.
The engine runs - Motor blocked by a
very loudly. foreign body.
- The capacitor is
defective or engine
The motor buzzes
problem.
but does not turn.
- Motor blocked by a
foreign body.
For any other problem contact the Customer Service or an authorized
repairman.
supply.
Solutions
- Check the installation
upstream.
- Clean or change the
check valve.
- Uncork the vent.
- Call a plumber.
- Review installation.
- Unplug, remove the pump
and lead background.
- Connect the equipment.
- Repair the outlet.
- Consult a licensed
convenience store.
- See instructions to check
the status of engine.
- Call your store.
- See instructions to check
the status of engine.
15) Warranty conditions:
The unit is guaranteed for 2 years from the date of purchase subject of
an installation and normal use: evacuation of sanitary water only.
The warranty is limited to replacement or repair in our workshops of
defective parts.
In no case the guarantee implies the possibility of a claim for damages
or compensation.
Postage and packing, travel expenses are not covered by our warranty.
The guarantee does not apply to replacement or repairs resulting from
normal wear and tear, deterioration or accident due to negligence, lack
of supervision or maintenance of faulty installation and all other defects
beyond our control.
Our guarantee immediately and completely disappears if the client has
modified or repaired without our hardware provided.
The repair, modification or replacement of parts during the warranty
period can not have the effect of extending the warranty period of the
equipment.
If our responsibility should nevertheless be involved, it would be
limited for all damages to the value of the goods supplied by us and
implemented by us.
The guarantee takes effect from the acquisition date on the invoice the
distributor.
This invoice is required before implementation of the guarantee.
Texts and drawings are not contractual, the manufacturer reserves the
right to make any changes without notice throughout its range as well
as the technical and commercial documents.
GB