Electrical Installation - Zanussi ZCG661G Benutzerinformation

apply force to the wire of the thermocouple conduc-
tor (F).
4. Release the burner injector (D) with a 7 mm socket
spanner and remove it. Replace it with the necessary
one.
5. Assemble the burner in the opposite sequence.
6. Replace the gas type sticker near the gas supply
ramp with the one related to the new gas type.
Replacing the grill burner injector:
1. Release the screw which keep the grill burner in po-
sition.
2. Release the burner injector with a 7 mm socket
spanner and remove it. Replace it with the necessary
one.
3. Assemble the burner in opposite sequence. Before
you fix the screw, make sure that the burner is push-
ed correctly to the back panel.
Minimum level adjustment of the oven burner:
1. Disconnect the mains plug from the mains socket.
2. Remove the knob for the oven functions.
3. Adjust the by-pass adjustment screw (A) with a thin-
bladed screwdriver.
A
Change of the type of
gas
From natural gas to liq-
uid gas
36
Adjustment of the ad-
justment screw
Fully tighten the adjust-
ment screw in.
Change of the type of
gas
From liquid gas to nat-
ural gas
4. Attach the knob for the oven functions.
5. Put the mains plug into the mains socket.
Warning! Only put the mains plug into the mains
socket when all parts are back into their initial
position. There is a risk of injury.
6. Light the gas oven burner. Refer to section "Gas
oven cooking: Ignition of the gas oven burner".
7. Set the knob for the oven functions to maximum and
let the oven heat for at least 10 minutes.
8. Turn the knob for the oven functions from maximum
to minimum.
Control the flame. If the flame goes out, do the procedure
from point 1 to point 7 again. There must be a small regu-
lar flame on the oven burner crown.
The grill temperature cannot be adjusted. To obtain
a lower temperature or slower cooking time the grill
pan must be lowered away from the flame.
The manufacturer declines liability if you do not obey
these safety measures.
Levelling
Use small feet on the bottom of appliance to set same lev-
el of cooker top surface with other surfaces

Electrical installation

The manufacturer is not responsible if you do not
follow safety precautions from chapter "Safety infor-
mation".
This appliance is supplied with a main plug and a main
cable.
Adjustment of the ad-
justment screw
Release the adjustment
screw approximately
3/4 of a turn.