What To Do If - Zanussi ZCG661G Benutzerinformation

3
Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove it from
its seat.
3
2
2
5
Use a spatula made of
wood or plastic or equiva-
lent to open the inner
door.
Hold the outer door, and
push the inner door
against the top edge of the
door.

What to do if...

Problem
There is no spark when lighting the
gas.
There is no spark when lighting the
gas.
1
1
4 Place the door on a
stable surface protected by
a soft cloth.
Use a screwdriver to re-
move 2 screws from the
bottom edge of the door.
Important! Do not lose the
screws.
.
6
Lift the inner door.
7
Clean inner side of the
door.
Clean the glass panel with
water and soap. Dry it
carefully.
Possible cause
There is no electrical supply.
There is no electrical supply.
Warning! Only clean the glass panel with water and
a soap. Abrasive cleaning agents, stain removers
and sharp objects (e.g. knives or scrapers) can cause
damage to the glass.
Inserting the door and the glass panel
When the cleaning procedure is completed, insert the
oven door. To do so, do the steps in opposite way.
4
4
6
5
5
Oven lamp
Warning! Be careful! There is the risk of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C
heat-resistant oven light bulb.
Use the same oven lamp type.
4. Install the glass cover.
Make sure that the unit is connected
and the electrical supply is switched
on.
Examine the house electrical installa-
tion fuse.
Remedy
31