Denon AVR-1404 Bedienungsanleitung Seite 20

ENGLISH
4
Set the surround parameter according to the source.
First, press the SURROUND PARAMETER button.
NOTE: Please make sure the "AUDIO" position of the slide switch on the
remote control unit.
(Remote control unit)
5
Use the
CINEMA EQ OFF
(Remote control unit)
Press the SURROUND PARAMETER or
COMP. setting.
(Remote control unit)
6
Use the
(Remote control unit)
Press the SURROUND PARAMETER or
setting.
(Remote control unit)
NOTE: This parameter is not displayed during DTS playback.
7
Use the
(Remote control unit)
• The level can be adjusted in units of 1 dB from –10 to 0 dB.
Set to the desired level according to the speaker systems being used and the
source to be played.
Press the SURROUND PARAMETER or
default setting.
(Remote control unit)
8
To reset the settings to the factory defaults, use the
display "Yes".
DEFAULT
(Remote control unit)
Press the SURROUND PARAMETER or
CINEMA EQ. setting.
(Remote control unit)
20
(left) and (right) buttons to set the CINEMA EQ.
(Initial)
ON OFF
(left) button (right) button
(down) button to switch to the D.
(left) and (right) buttons to set the D. COMP.
(Initial)
OFF LOW MID
D.COMP. OFF
(left) button
(down) button to switch to the LFE
(left) and (right) buttons to set the LFE level.
-10dB -5dB
LFE 0dB
(left) button (right) button
(down) button to switch to the
(left) and
YES Y/N
Y/N
(left) button (right) button
(down) button to switch to the
NOTE:
• When making parameter settings, the display will return to the regular condition several seconds after the
last button was pressed and the setting will be completed.
Surround parameters w
CINEMA EQ. (Cinema Equalizer):
The Cinema EQ function gently decreases the level of the extreme high frequencies, compensating for
overly-bright sounding motion picture soundtracks. Select this function if the sound from the front speakers
is too bright.
This function only works in the Dolby Pro Logic, Dolby Digital and DTS Surround modes.
D.COMP. (Dynamic Range Compression):
Motion picture soundtracks have tremendous dynamic range (the contrast between very soft and very loud
sounds). For listening late at night, or whenever the maximum sound level is lower than usual, the Dynamic
Range Compression allows you to hear all of the sounds in the soundtrack (but with reduced dynamic range).
(This only works when playing program sources recorded in Dolby Digital.) Select one of the four parameters
("OFF", "LOW", "MID" (middle) or "HIGH" (high)). Set to OFF for normal listening.
LFE (Low Frequency Effect):
Program source and adjustment range
1. Dolby Digital: –10 dB to 0 dB
2. DTS Surround: –10 dB to 0 dB
HIGH
When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set
to 0 dB for correct Dolby Digital playback.
(right) button
When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to
0 dB for correct DTS playback.
When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to
-10 dB for correct DTS playback.
(Initial)
0dB
(right) to
NO