Worx Professional WU651 Handbuch Seite 9

Operating instructions
Note: Before using the tool, read the instruction book carefully.
KNOW YOUR RANDOM ORBIT SANDER
Vibrafree ™ Random Orbit Sander are uniquely designed with two
counter balanced sanding pads that always move in opposite directions to
each other.This design platform virtually cancels out the sander's vibration
in every load condition. This active vibration canceling technology makes
this sander more comfortable and easy to use, taking the vibration out of
the sander, the workpiece, your hands and arms, and putting this energy
to work sanding and removing material.
1
FITTING THE SANDING PAPER (See Fig A)
Sanding paper is easily attached on the pad of your sander. Fit the
inner spot paper over the plate so that it covers the entire area, push
and slightly twist to make sure the coated sanding paper is even on
the plate. Operate like this when fit the outer ring paper. Make sure
the sanding paper is even with the edges and that the sanding paper
is taut on the pad.
Remove the abrasive paper by pinching an edge and peeling off (See
Fig B)
2 CYCLONIC DUST BOX (See Fig C)
A) Attach the cyclonic dust box
Your sander is equipped with a cyclonic dust box. To attach, slide
the box onto the outlet piece and take care that the latching lever
engages.
Caution: To prevent the possibility of sanding dust or foreign
body being thrown into your face or eyes, never attempt to use your
sander without the box properly installed.
B) Empty the cyclonic dust box (See Fig D1,D2)
For more efficient operation, empty the cyclonic dust box every
5-10mins. This will permit the air to flow through the box better.
To empty the box, press the latching lever in and pull off the box. Then
press the button at the rear of the box to open it, and shake out dust.
3 USING THE DUST EXTRACTION ADAPTER (See Fig.E)
Your sander is equipped with a dust adapter, which is designed for
collect dust task. To attach, slide the adapter onto the outlet piece
and take care that the latching lever engages. Then connect the hose
of a vacuum cleaner. First please turn on the vacuum cleaner, and
then turn on the sander. if you stop sanding, first turn off the sander,
then turn off your vacuum cleaner.
4 OPERATING THE SWITCH (See Fig F)
To start your sander, depress the protective cover over the switch at
9