Worx Professional WU651 Handbuch Seite 11

Working hints for your random
orbit sander
if your power tool becomes too hot, especially when used at low
speed, set the speed to maximum and run it with no load for 2-3
minutes to cool the motor. Avoid prolonged usage at very low
speeds. Always use sand paper that is suitable for the material you
want to sand.
Always ensure the work-piece is firmly held or clamped to prevent
movement.
Any movement of the material may affect the quality of the sanding
finish.
Start your sander before sanding and turn it off only after you stop
sanding. For the best results, sand wood in the direction of the grain.
Do not start sanding without having the sandpaper fitted.
Do not allow the sand paper to wear away it will damage the base-
plate. The guarantee does not cover base-plate wear and tear.
Use coarse grit paper to sand rough surfaces, medium grit for
smooth surfaces and fine grit for the final surfaces. if necessary, first
make a test run on scrap material.
Use only good quality sand paper.
The sand paper controls the sanding efficiency, not the amount of
force you apply to the tool. Excessive force will reduce the sanding
efficiency and cause motor overload. Replacing the sand paper
regularly will maintain optimum sanding efficiency.
Accessory
•
Dust extraction adaptor
• Cyclonic dust box
• 60 grit velcro sanding paper
•
120 grit velcro sanding paper
•
180 grit velcro sanding paper
We recommend that you purchase your accessories from the same
store that sold you the tool. Use good quality accessories marked
with a well-known brand name. Choose the type according to the
work you intend to undertake. Refer to the accessory packaging for
further details. Store personnel can assist you and offer advice.
11
1
1
5
5
5