Operating The Receiver; Main Menu; Installation; Lnb Setting - Samsung DSB-9601C Gebrauchsanweisung

OPERATING THE RECEIVER

Main Menu

After installing your antenna system and DSB-9601C with appropriate connectors.
Plug in the AC main power and switch on the receiver.
Press the MENU key to bring up the main menu.
The LED display will show "MENU".
The following on screen display will appear:
The sub menu topics will be displayed.
Before you begin with the "Installation" menu,
you should check in the 4th menu "System Setup"
whether all the information there is applicable for you.
Input the PIN code before selecting the Channel Orgarnizing and
Parental Lock menu.
Set the Satellite Connection Type in the "System Setup" menu,
Select the System Setup by pressing the MENU key and
then press the OK key or key.
Select the Satellite Connection by pressing the
Select the desired connection type by pressing the
If two tuners share one LNB, select Loop Through. If a service is being recorded, the other tuner
can receive only the signal of the same band and polarity as being recorded in this configuration.
If the tuners are connected to separated LNBs (or Dual LNB), select Separate A, B.
There is no restriction as in the Loop Through configuration.
N N o o t t e e : It is not allowed to enter Satellite B setting menu in Loop-through mode.

1. Installation

This menu consists of 5 sub-menus:
Select the satellite A or B by pressing the SAT A/B key.
Select "Installation" in the main menu mode to select the
sub menu.
Enter the PIN Code.
If you have not entered your own PIN Code then the PIN Code
0000 applies, which was set at the factory.
GB-20
/ keys,
/ keys and OK key .
/ keys and OK key.
P E R S O N A L V I D E O R

1.1 LNB Setting

You can select the satellite and LNB setting conditions to
execute channel search and you can alter the settings for
22KHz tone.
The parameters set in this menu are needed for programming
the channels for the "Auto scanning" and "Manual scanning".
The necessary information can be found at your antenna and
LNB brochures, or you can ask your dealer.
Select LNB power supply "On".
N N o o t t e e : If the LNB power is set to "Off", channels will not be scanned.
Select the desired satellite name.
Select the LNB type (frequency).
Select the DiSEqC Mode (Off, DiSEqC A, DiSEqC B, DiSEqC C, DiSEqC D, Tone Burst A,
Tone Burst B)
If you are using a Positioner, select Positioner DiSEqC1.2 . ("Yes" or "No")
Tone 22KHz: In case you are using a dual LNB or two antennas connected to a 22KHz
tone switch box, with the 22 KHz tone switch ("Auto", "On" or "Off") you can
switch between both LNB or antennas.

1.2 Positioner Setting

If you have a DiSEqC 1.2 motorized system, then you can take
advantage of the DiSEqC 1.2 functions available.
Select Satellite.
Select any transponder from above satellites and check out
the Frequency, Symbol Rate, FEC and Polarity.
In case problems arise, ask your dealer.
Select from Menu Mode:
User Mode
" " : This is used to fine-tune the position of
the motor for better reception.
General user uses "User Mode".
"Installer Mode" : This is used to search for the position of a satellite manually.
E C O R D E R C O M M O N I N T E
OPERATING THE RECEIVER
GB-21
R F A C E