Specifications - Ingersoll-Rand 261 Serie Gebrauchsanweisung

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll- - Rand No. 50
Always use of an air line lubricator with these tools.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
For International- - No. C18- - C3- - FKG0
For USA - - No. C18- - 03- - FKG0- - 28
After each forty- - eight hours of operation, or as
experience indicates, inject about 4 cc of the
recommended grease into the Grease Fitting (12).
Model Type of
Handle
261, pistol
261- - EU
261- - 3, pistol
261- - 3- - EU
261- - 6,
261- - 6- - EU
271, pistol
271- - EU
Tested in accordance with PNEUROP PN8NTC1.2
H
♦ Tested to ISO8662- -7
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620kPa)
PLACING TOOL IN SERVICE
Ingersoll- - Rand No. 100

SPECIFICATIONS

Drive Impacts
per min.
in.
3/4" sq. 1,000
3/4" sq. with 1,000
extended anvil
1" sq. 1,000
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Recommended
Torque Range
ft- - lbs (Nm) Pressure
200- - 600
(271- - 813)
200- - 600
(271- - 813)
100- - 750
(136- - 1017)
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905- -1)
Sound Level
H
dB (A)
Power
101.1 114.1
101.1 114.1
101.1 114.1
WARNING
♦Vibrations
Level
2
m/s
6.1
6.8
7.3