TermaTech TT20 Montage- Und Bedienungsanleitung Seite 23

UK
User and mounting manual
Please read also:
SUPPLEMENTARY INSTALLATION INSTRUCTIONS FOR
THE UK MARKET (last 6 pages)
CE approved according to:
EN13240
NS3058+NS3059
Congratulations on your new wood-burning stove.
We thank you for choosing a TermaTech wood-burning stove and wish you many cosy and warm
moments in the future.
Before using the stove you should read the user and mounting manual and also the SUPPLEMEN-
TARY INSTALLATION INSTRUCTIONS FOR THE UK MARKET (last 6 pages of this manual) so you
are familiar with the legal requirements as well as the instructions regarding maintenance. By this
it is ensured that the product works as it is intended and you get the most out of your investment
for many years to come.
Installation/user instruction..................................
Installation instructions in "smoke control areas"..
Lighting instruction................................................
Maintenance...........................................................
Warranty/right to invoke lack of conformity..........
Hints......................................................................
Supplementary Inst. Instructions UK.....................
Drawing concerning smoke control kit....................
INSTALLATION INSTRUCTION
The stove is intended for intermittent combustion. It is not meant to "heat over" at night. By fol-
Remedy of malfunctions / FAQ...............................
combustion is achieved.
Technical specifications..........................................
The wood-burning stove is delivered ready for mounting (the exhaust branch may need to be
screwed on) and must be connected to the chimney with a smoke pipe. The connection between
stove and chimney must, as far as possible, be mounted in one straight piece (with as few bends
as possible) and as minimum horizontally, but preferably rising from the stove to the chimney.
Joints must be tight. Remember that it has to be possible to clean the pipe (possibly with a clea-
ning hatch on the pipe).
lowing the instruction below in "Lighting instructions" the best and most environmentally friendly
Any unauthorised changes to the wood-burning stove will be viewed as a structural change and
thereby the warranty will be void and is also a risk to safety.
In the door on your TT stove there is a spring that makes the door close by itself when you let go
of the handle.
This closing device is not a demand in the UK, Denmark and many other countries and can the-
refore be removed. In the bottom hinge the split with lentil head is removed which removes the
tension from the spring. This is most easily done by using a small screw driver and side-cutting
pliers.
National and European norms
The regulations in force at the time in question, including those that refer to national and Euro-
pean standards, must be respected when installing the wood-burning stove. Contact your local
dealer for further advice and guidance in connection with mounting. Notify your Hetas installer
combustion in the stove, so care must be taken concerning closely shut windows and doors that
Safety references
The surface of the stove as well as knobs, handle, window, smoke pipe, etc. become very hot
when the stove is in use. Touching these parts without necessary protection (glove or other pro-
tective material) can lead to burns.
before you use your wood-burning stove. It must be ensured that there is sufficient airflow for the
may hinder the flow of air to the combustion.
Page 23
Page 25
Page 25
Page 26
Page 26
Page 27
Page 30
Page 34
Page 28
Page 29
23