Dtp131 Dtp141 - Makita DTP131 Bedienungsanleitung

When drilling into concrete or tiles, point the arrow at
the mark for hammer drill mode.
When drilling into wood or metal, point the arrow at
the mark for drill mode.
When driving small wood screws or machine screws,
point the arrow at the
The fastening torque can be adjusted on the LED
display.
Changing the impact force (impact driver mode)
2
3
4
1. Changed in three steps 2. Hard 3. Medium 4. Soft 5. Control button
Impact force grade
displayed on panel
Hard
Medium
Soft
The impact force can be changed in three steps: hard, medium and soft.
This allows a tightening suitable to the work.
Every time the button
For approximately one minute after releasing the switch trigger, the impact force can be changed.
mark for screwdriver mode.
1
5
Maximum blows
DTP131 DTP141
3,200 3,200 Tightening when force
-1 -1
(min ) (min ) and speed are desired.
2,400 2,400 Tightening when a good
(min ) -1 (min ) -1 finishing is needed.
Tightening when excessive
tightening need to be avoided
1,200 1,200
because of potentially clogged
(min ) -1 (min ) -1
female screw and broken or
damaged screw head.
is pressed, the impact force grade changes in three steps.
CAUTION:
• Always set the arrow correctly to either mode
mark. If you operate the tool with the action
mode changing ring positioned halfway between
the mode marks, the tool may be damaged.
• When turning the action mode changing ring,
make sure that the tool stops. If the ring does
not easily move, pull the switch trigger slightly to
rotate the spindle and then move the ring.
• In the hammer drill mode or drill mode, the blow-
ing force or torque is not adjustable. In those
modes, the number on the LED display will be off.
Application
8 ENGLISH
Work
Tightening in underwork
material/ Tightening long
screws/ Tightening bolts.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws
such as M6.