Operation - Makita VC3211H Bedienungsanleitung

the base hook. Using the cleaner or the
connected electric power tool with power supply
cord may cause damage the power supply cord.
2. Storing the front cuffs
Fig.7
Front cuffs 22, 24 and 38 can be stored (up to two at a
time).
3. Storing the hose
Fig.8
4. Resting a reasonable size of electric power
tool for the base hook, such as circular saw.
Fig.9
Locking or unlocking the caster
Fig.10
To lock the caster with a stopper, lower the stopper lever
and the caster no longer will rotate. To release the
caster from the locked position, raise the stopper lever.
Locking the caster is convenient when storing the
cleaner, stopping the work on the way and keeping the
cleaner still.
To operate the stopper, move it by hand.
NOTICE:
When moving the cleaner, make sure that the
•
caster is unlocked. Moving the cleaner with the
caster in the locked position may cause damage to
the caster.
Cap
There is a cap on the mounting port. The cap prevents
the vacuumed dust from getting out from the cleaner.
ASSEMBLY
WARNING:
This unit may contain hazardous dust. When
•
replacing filter elements and dust bag, always use
a P2-respirator.
Always be sure that the cleaner is switched off and
•
unplugged before carrying out any work on the
cleaner.
Never switch on until all filters and dust bag are
•
completely installed and the volume flow control is
tested.
Warning sticker
Fig.11
Put the warning sticker of your language in the frame of
warning label on the cleaner.
Installing and disposing the filter bag
WARNING:
Always use a P2-respirator.
•
When using the filter bag, also use the air filter
•
together that is preinstalled on the tool. Failure to
use the air filter together may cause unusual noise
and heat, resulting in a fire.
CAUTION:
Never pick up water or other liquids or wet dusts
•
when using the filter bag. Picking up such things
may cause the filter bag breakage.
Fig.12
1. Extend the filter bag.
Fig.13
2. Align the filter bag opening with the dust suction
opening of the cleaner.
3. Insert the cardboard of the filter bag onto the tool
so that it is positioned at the end beyond the
detent protrusion.
When disposing the filter bag, pull the edge on the filter
bag's mouth so that the mouth is closed by a paper.
Connecting a hose
CAUTION:
Never force the hose for bending or stamp it.
•
Never move the cleaner by a hose. Forcing,
stamping and pulling the hose may cause a
breakage or deformation of the hose.
When picking up large wastes such as planer
•
carvings, concrete dusts or similar other than
small wastes, use the 38 mm inner diameter hose
(optional accessory). Using the 28 mm inner
diameter hose may cause a hose stuffing and
damage.
Always put the cap on the mounting port whenever
•
you remove the hose from the tool.
Fig.14
Remove the cap from the mounting port. You can place
the cap in multi hook while the hose is connected to the
tool.
Fig.15
Insert the hose onto the mounting port of the tank and
turn it clockwise until it locks.

OPERATION

WARNING:
Always use a P2-respirator.
•
CAUTION:
If foam or liquid escapes from the tool, switch off
•
immediately. Continuing to using in this condition
may cause an electric shock and breakage of the
cleaner.
9