Important Safety Advice Safety System - Silvercrest FW 10 Handbuch

Important safety advice / Safety system
100 as proven in tests at the Hohenstein Research
Institute.
Do not place the foot warmer on to parts of the
body that are inflamed, injured or swollen. If in
doubt, take medical advice before use.
RISK OF BURNS! Excessively
long use can cause skin burns.
ATTENTION! Under no circumstances fall
asleep while the foot warmer is in use.
Under certain circumstances, the
electrical and magnetic fields emitted
from this foot warmer could interfere
with the proper functioning of your heart pace-
maker. However, the values are well under the
permitted limits: electrical field strength: max.
5000 V / m, magnetic field strength: max. 80 A / m
magnetic flux density: max. 0.1 millitesla. Ask
your doctor and the manufacturer of your heart
pacemaker before you use this foot warmer.
When using this foot warmer
– connect it only to an electricity supply of the
voltage shown on the device,
– do not leave it operating unattended,
do not switch it on if it is folded or
drawn together,
– do not allow it to become trapped,
– do not bend it sharply,
– do not use it on animals,
– do not use it if it is damp or moist.
The electronic components in the foot warmer's
control unit cause the control unit to heat
2
up slightly during operation. The control unit
must therefore not be covered or placed on the
foot warmer when it is operating.
Do not pull on the leads or wires, twist or
sharply bend them.
RISK OF ELECTRIC SHOCK! Do
not stick needles or sharp objects
into this foot warmer.
8 GB/IE
67225_silv_Fußwaermer_Content_LB3.indd 8
The textiles used in this
foot warmer meet the
high human ecological
safety requirements of
the Öko-Tex Standard
2
RISK OF INJURY! This foot warmer
must not be used by children unless
the control unit
by a parent or a supervising person or the
child has been adequately instructed how to
use this foot warmer safely.
Children should be supervised in order to ensure
that they do not play with the foot warmer.
RISK OF ELECTRIC SHOCK AND
INJURY! This foot warmer must be
frequently examined for signs of wear
or damage. If such signs are present or the wires
or leads are damaged or if this foot warmer
has been improperly used, it must be taken to
the manufacturer or his customer service centre
before further use.
Special tools are required for repairs, therefore
you must have any repairs carried out only by
qualified specialist personnel or in a workshop
approved by the manufacturer. Unsatisfactory
repairs can lead to considerable danger for
the user.
Have the foot warmer repaired
by qualified specialist personnel using original
manufacturer parts only. This will ensure that
the foot warmer remains safe to use.
If the mains lead to the foot
warmer is damaged, in order to avoid causing
further danger it must be replaced by the manu-
facturer or his customer services department.
Safety system
Note: The foot warmer is fitted with a SAFETY
SYSTEM. This electronic sensor system prevents the
foot warmer from overheating over its full area by
switching it off automatically in the event of a fault.
If the safety system switches the foot warmer off
automatically due to a fault, then the function indi-
cator on the control unit
3
even if the foot warmer is switched on.
Please note that, for safety reasons, the foot
warmer must not be used in the event of a fault
and must be sent to the service centre address
given below.
has been preset
2
ceases to illuminate,
2
04.05.11 10:17