Installation; Maintenance - Vimar Elvox TAB 7548 Technisches Handbuch

TAB: 7548
The instruction manual is downloadable from the site www.vimar.
com
Description
Wall-mounted Tab monitor for Due Fili Plus system with 4.3 in LCD
colour display, handset, loudspeaker for calls, capacitive keypad
for interphone functions: lock opening, self-start, auxiliary services,
intercom calls and volume, brightness and contrast control.
It is possible to differentiate the call chimes. The visual signals are
for "door/gate open," "missed calls," "user away" (configurable via
SaveProg only) and "chime muting."
Desktop installation is possible with the desktop base accessory
753A and the interconnecting stud 753B (sold separately). Wall
mountable also on 8-module back boxes (Vimar V71318, V71718)
with mounting frame 753S (sold separately).
*
Article 7548 can be used by people wearing hearing aids.
Technical characteristics
• Surface-wall mount or box installation. Can be fitted to the wall
with plugs or a 3 modules (Vimar V71303, V71703) or circular 60
mm flush-mounting box (Vimar V71701).
• LCD 4.3 in 16:9 display, resolution 480x272 pixels
• Minimum signal level on the bus in reception: -20 dBm
• Capacitive touch keypad with backlit symbols.
• Power supply for terminals 1, 2 (28 Vdc).
• Absorption:
- on standby: 10mA
- maximum conversation current: 180mA
- peak current limited to call time: 180mA
• Ambient class: Class A1 (indoor use)
• Protection class: IP30
• Operating temperature: -5° to 40°C
• Operating ambient humidity 10 - 80% (non-condensing)
• Electronic chimes with different tunes (10).
• Input for landing call.
• Dimensions: 160x180x45,4 mm
• DIP switch for line impedance termination.
Audio frequency function for hearing aids
Art. 7548 can be used by people wearing hearing aids.
However, for correct operation of the hearing aid refer to its instruc-
tion manual. Any metal objects or electronic equipment nearby may
compromise the quality of the sound received by the hearing aid.

Installation

Important: We recommend installing the device approximately 160
cm above the floor, making sure it is not exposed to direct light,
so as to avoid bothersome reflections on the surface of the LCD
screen.
Note: Fig. 1 shows the recommended installation distances, unless
otherwise specified by current regulations.
1. Secure the plate to the wall with plugs or on a box 3 modules
(Vimar V71303, V71703) or a circular mounting box size 60mm
(Vimar V71701).
2. Wire the terminal block (Fig. 6).
3. Terminate the video signal (Fig. 5)
4. Install the monitor as follows: position the monitor on the cou-
pling plate keeping it slightly raised. While keeping the face
plate pressed, apply a light downward pressure until it clicks
into place.
5. Should you need to remove the monitor you need to apply a
light pressure on the lever (Fig. 3) and raise it (from the bottom
upwards) so as to release the monitor from the chassis.

Maintenance

Clean using a soft cloth. Do not pour water onto the appliance and
do not use any type of chemical product.
Swiping your palm over the keyboard locks the buttons and all the
LEDs will blink for 5 seconds. The 5s timeout is renewed every
time a button is touched. After the 5s timeout the monitor will emit
another warning beep.
Warnings for the user
Do not open or tamper with the appliance.
In the event of trouble, call in specialized personnel.
Installation rules
Installation should be carried out by qualified personnel in
compliance with the current regulations regarding the installation of
electrical equipment in the country where the products are installed.
Conformity
EMC directive
Standards EN 60065, EN 61000-6-1, EN 61000-6-3 and EN
60118-4.
REACH (EU) Regulation no. 1907/2006 – Art.33. The product may
contain traces of lead.
WEEE - Information for users
If the crossed-out bin symbol appears on the equipment or
packaging, this means the product must not be included
with other general waste at the end of its working life.
The user must take the worn product to a sorted waste center,
or return it to the retailer when purchasing a new one. Products
for disposal can be consigned free of charge (without any new
purchase obligation) to retailers with a sales area of at least 400m
if they measure less than 25cm. An efficient sorted waste collection
for the environmentally friendly disposal of the used device, or its
subsequent recycling, helps avoid the potential negative effects on
the environment and people's health, and encourages the re-use
and/or recycling of the construction materials.
EN
,
2
3