Stopwatch Mode - Kalenji 900 Bedienungsanleitung

Use the same procedure as you would when setting the second 15-second timer.
The START/STOP button starts or stops the session. The timers succeed each other in numerical order
( T1-T2-T3... ) until they reach a timer programed with a zero value and then start again with T1 .
The repeat counter is incremented. If the rst timer is not T1 , the repeat counter is incremented just
before restarting the rst timer.
For example: 3 timers, T1 , T2 , T3 have been programed. The rst one for the session is T3 . The timer
increments after T3 then T1 then T2 have been completed, just before restarting T3.
• Beep sounds
In order to diff erentiate between the timers and the progress of the session, the end beeps are
diff erent:
End of a timer: 3 successive beeps. End of a repeat: 2x3 successive beeps. End of the session: 4x3
successive beeps.
For the previous example:
Start!
TIMER 1: 45s. 3 successive beeps
TIMER 1: 45s. 3 successive beeps
Timer 2: 15s. 2x3 successive beeps Timer 2: 15s. 2x3 successive beeps
Timer = 1/3 Timer = 2/3
12
TIMER 1: 45s. 3 successive beeps
Timer 2: 15s. 4x3 successive beeps
Timer = 3/3
End of the session.
Pressing the START/STOP button stops the timer.
Pressing the SPLIT/RESET button resets the repeat counter to zero and resets the timer to its start
time.

7 / Stopwatch mode

7.1 Stopwatch functions
13