Cleaning And Maintenance; Troubleshooting - Concept SR3340 Bedienungsanleitung

sources of heat. Insert the plug into the electric voltage outlet.
4. Hold the body with one hand and the mixing container with the other.
5. Insert the extension into the mixing vessel with food and select the required speed, 1-5. While mixing, use
circular movements on the bottom. By using the TURBO button, you may increase the motor rotation speed to
the maximum for a short time. Do not insert the extension into the processed food or remove it from the food
while it is moving.
6. Switch the unit off after mixing. Disconnect the cable from the socket.
7. Release the rod extension by turning it and rinse it immediately under running water (see Cleaning and
Maintenance). Close the rear cover by inserting it.

CLEANING AND MAINTENANCE

Turn off the unit and disconnect the power cord from the wall outlet before cleaning and after use.
Clean the appliance body with a wet cloth.
Do not use steel wool, abrasive agents or solvents to clean the unit.
Wash the whisks and hooks in tepid water with detergent and rinse in clean water; you may use a dishwasher.
Do not immerse the rod extension into water! Just wash it. Make sure the water does not enter the extension,
where the driving spindle is. If this happens, leave the rod extension to dry and apply a few drops of vegetable oil
to smoothen the operation of the extension bearings.

TROUBLESHOOTING

Problem
The motor is not
running.
The motor has stopped
working.
SERVICING
Any extensive maintenance or repair requiring access to the inner parts of the product must be performed by an
expert service centre.
24
Cause
The plug is inserted into the socket
incorrectly or insufficiently.
The socket is not receiving electricity.
The cover of the rod extension hole is
not properly closed.
The extension rod is not attached
properly.
The motor is overloaded, the heat fuse
has been activated.
Solution
Check the plug connection.
Check for voltage, e.g. by connecting
a different appliance.
Close the cover properly.
Check the extension rod attachment.
Disconnect the power supply cable
from the socket. Check and clear the air
passage at the inlet/outlet grills.
Let the unit cool.
EN
SR3340