Control, Cleaning, Sanitization Of Machine; Basic Safety Standards For Machine Maintenance - Orved N Serie Bedienungs- Und Wartungsanleitung

CONTROL, CLEANING, SANITIZATION OF MACHINE

9. CONTROL, CLEANING, SANITIZATION OF MACHINE
Implementing the scheduled maintenance regularly, as described further on in this manual, minimises and/or eliminates
potential faults and interference and increases the machine lifetime significantly.
Failure to perform regular maintenance can lead to significant repair costs, and in certain cases, render the guarantee
null and void.
Furthermore, a good standard of hygiene is maintained if that indicated is complied with

9.1 BASIC SAFETY STANDARDS FOR MACHINE MAINTENANCE

To carry out cleaning and routine maintenance operations safely, follow the regulations provided below:
ELECTRICAL HAZARD! If the power supply cable is damaged, it must be replaced by the manufacturer
or an authorized service center.
ELECTRICAL HAZARD! The power sources must be disconnected before cleaning, disinfecting, performing main-
tenance and/or repairing any component of the machine (disconnect the electrical plug from the mains).
DANGER! It is strictly prohibited to remove the guards and safety devices to perform routine maintenan-
ce. ORVED S.p.A. declines all liability for accidents due to non-compliance with the above-mentioned
obligation.
ATTENTION!
Always use suitable preventive measures and protective devices (gloves, etc.) for any maintenan-
ce, handling, installation and cleaning operations.
WARNINGS!
• Only qualified technicians must perform maintenance or access live parts of the machine.
• Contact a Technical Support Centre authorised by the manufacturer for any repairs. Only original spare parts
must be used and requested.
• Do not perform maintenance yourself where the intervention of a qualified technician is indicated in the manual.
• Do not touch the machine with bare, damp or wet hands or feet.
• Do not insert screwdrivers, kitchen instruments or anything similar between the guards, openings and moving
parts of the machine.
38
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N