Orved N Serie Bedienungs- Und Wartungsanleitung Seite 29

POS. COMPONENT
Main switch
1
Vacuum gauge
2
Cursor key (UP)
3
Programming key
4
(PROG)
Cursor key (DOWN)
5
key to select
6
functions (SEL)
key to activate
7
pump and jar
functions (PUMP)
STOP key
8
Lower and upper 6+6
9
digit display
10
6 bright icons
11
6 lower LEDs
12
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N
FUNCTION
• Switches the machine "ON/OFF"
• Emergency stop.
• Indicates the vacuum in the chamber.
• Scrolls through the programs.
• Changes the values of the functions.
• Scrolls through the languages of the display.
• Pressed together with "STOP" upon start-up, it allows to reset stored programs and restores the factory
settings.
• Allows to access the programming of a function.
• Confirms the value or function set.
• Activates the sensor calibration function if pressed upon start-up.
• Pressed for 4 seconds, allows storage of custom user program name.
• Scrolls through the programs.
• Changes the values of the functions.
• Scrolls through the languages of the display.
• Scrolls through the internal functions of a program.
• Activates the programming of the display language if pressed upon start-up.
• Allows to move to the next function in advance.
• It activates the continuous pump cycle.
• Pressed together with the "STOP" key, it allows to display the machine's serial number.
• Pressed upon start-up together with the "STOP" key, it allows to display the number of cycles performed
before the oil must be replaced.
• Interrupts the cycle in progress
• If pressed for 4 seconds, it activates/deactivates the buzzer.
• Pressed upon start-up together with the "PUMP" key, it allows to display the number of cycles performed
before the oil must be replaced.
• Pressed together with the "PUMP" key, it allows to display the machine's serial number.
• Pressed together with the"UP" key upon start-up, it allows to reset stored programs and restores the factory
settings.
• They display the active program.
• They display the active function and the relative value set, together with the numerical progress of the set value.
• They display alarm warnings.
• They display the machine's serial number.
• They display the number of cycles performed before the oil must be replaced.
Indicates the pump works.
Indicates the vacuum phase.
Indicates the additional vacuum phase.
Indicates the phase of gas injection.
Indicates the phase of sealing.
Indicates the air return phase.
• They display the progress of the current cycle.
• They display alarms.
• They provide a graphical indication of the number of cycles performed before the oil must be replaced.
OPERATION VGP25N
29