Orved N Serie Bedienungs- Und Wartungsanleitung Seite 26

INSTALLATION AND PREPARATION
9) Choose the language of the display.
VGP25N: The machines are usually supplied with the language used in the country of destination of the machine.
If you still want to choose a different language from those available (English, Italian, Spanish, French and German),
proceed as follows:
Turn the machine on using the ON/OFF main switch and simultaneously press the
"SEL" button.
Choose the language by pressing the "UP" and "DOWN" buttons.
Confirm your selection with the "PROG" button, or wait 20 seconds after which, the
choice is saved.
VGP60N: Switch the machine on, and select the favorite language on the menu, among the available ones
(Italian, English, French, German and Spanish).
10) Calibrating the vacuum sensor.
At the first use, it's necessary to calibrate the vacuum sensor, in order to adjust it at the altitude of working place.
Without this adjustment, the machine cannot create an adequate vacuum.
Proceed as follows:
MOD. VGP25N
PHASE DESCRIPTION
1
Turn the machine on using the "ON/OFF" main switch and simultaneously press
the "PROG" button.
2
Close the heating station.
The machine starts the cycle, which ends after approximately 2 minutes.
3
The heating station opens automatically at the end of the calibration.
4
The machine returns to the default program or the previously set program.
26
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N
kEY