RIB IDRO Serie Bedienungsanleitung Seite 19

E
LECTRICAL SAFETY DEVICES
In addition to compliance to all mechanical safety regulations, gates
with leaf length exceeding 1.8 m must be fitted with two pairs of
photocells capable of interrupting gate movement.
The photocells must be installed at a height of 40 - 60 cm between the
gate posts on the outside of the structure.
The other two photocells must be installed at the same height as the
previous ones on the ends of the gate leafs to form a barrier between
the leafs when open.
Gate movement must be indicated by a flashing unit placed near the
gate.
Use the (KS2 o K2) (for one or two single-phase motors) electronic
control unit.
For connections and technical data of accessories refer to the
appropriate booklets.
M
AINTENANCE
To be undertaken only by specialized staff after disconnecting
power supply.
Lubricate the hinges and check the oil level and thrust force generated
by the operator on the gate once a year.
M
ANUAL OPERATION WITH HEXAGON KEY
(IDRO27 - 27S)
Insert the key into the unlocking device
Rotate the key for a half turn in the anti-clockwise without forcing it
Carefully, manually operate the gate.
Reset automatic operation by completely rotating the key clockwise
until it stops.
M
ANUAL OPERATION WITH PERSONALIZED KEY
(IDRO 39)
Open the RIB cap.
Insert the key into the lock. Turn the key 90° in anti-clockwise sense,
without forcing it.
Then manually operate the gate by smoothly pushing the gate swing.
To reset automatic operation, set it to the initial position, remove the key
and close the cap to prevent water and powder from entering the
unlocking device.
WARNING: During manual operations be sure that the motor is off.
CAUTION: Models IDRO27S/R and IDRO39/R (reverse type) always
feature the unlock mode. In this case the unlock mode
allows the adjustment (increase/decrease) of stroke
reversibility, to avoid undesired wing gate movement in
presence of wind.
In order to carry out the manual operation of the gate leaf the followings
must be checked:
- That the gate is endowed with appropriate handles;
- That these appropriate handles are placed so to avoid safety risks for
the operator;
- That the physical effort necessary to move the gate leaf should not be
higher than 225 N, for doors/gates for private dwellings, and, 390N for
doors/gates for commercial and industrial sites ( values indicated in
5.3.5 of the EN 12453 norm).
F
ORCE ADJUSTMENT
Use a screwdriver to increase the force by rotating clockwise the
opening valve (grey) and the closing valve (yellow) (located above the
operator IDRO27-27S and below the cap after You have unscrewed the
4 screws with IDRO39).
Decrease the force by rotating anti-clockwise the opening and closing
valves.
WARNING: When adjusting the force, smoothly and gradually rotate
the valves without screwing them or unscrewing them
completely.
We suggest to you to adjust the valves in a way that the pressions are
not different between themselves.
Adjust the opening pressure a little higher than the closing.
IDRO 27-27 Super
IDRO 39
G G
B B
4
5
6