Safety Information - PMK PML Serie Bedienungsanleitung

PML SERIES

Safety Information

To avoid personal injury and to prevent fire or damage to this product or products connected to
it, review and comply with the following safety precautions. Be aware that if you use this probe
assembly in a manner not specified the protection this product provides may be impaired.
Only qualified personnel should use this probe assembly.
Use only grounded instruments.
Do not connect the probe ground lead to a potential other than earth ground. Always
make sure the probe and the measurement instrument are grounded properly.
Connect and disconnect properly.
Connect the probe output to the measurement instrument and connect the ground lead to
earth ground before connecting the probe to the circuit under test. Disconnect the probe
input and the probe ground lead from the circuit under test before disconnecting the probe
from the measurement instrument.
EN
Observe probe and probe accessory ratings.
Do not apply any electrical potential to the probe input which exceeds the maximum
ratings of the probe or the accessories connected to it. In a combination always the lower
rating / measurement category applies to both probe and accessories connected to it.
Make sure to comply with the voltage versus frequency derating curve on page 26.
Keep away from live circuits.
Avoid open circuitry. Do not touch connections or components when power is present.
Do not operate with suspected failures.
Refer to qualified service personnel.
Indoor use only.
Do not operate in wet/damp environment. Keep product surfaces dry and clean.
Do not operate the product in an explosive atmosphere.
22