Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Select the desired mode using the buttons
–
(see Fig. A):
5
10
– Set the brightness by using one of the five
different brightness buttons
Note: The brightness buttons cannot be
used in the automatic colour change mode
(button A
).
8
– Press the M button
of the light manually. With each new press
of the M button, the colour changes into
different colours.
– If you store a desired colour during the
automatic colour changing sequence or
M mode by pressing the S button
stored colour will be displayed when the
device is switched on again.
– Press the A button to switch on the
automatic colour-changing function.
– Press the button
9
light.
– Press one of the colour buttons
into the desired colour directly.
Note: The remote control handset has a
range of 4 metres. Hold the remote control
handset with the IR diode
pointing directly at the lamp.
26 GB/MT
.
5
to change the colour
6
. The
7
to change to white
to change
10
above and
14
Replacing a bulb
Press the 0 button
to switch off the
3
colour-changing lamp.
Allow the lamp
to cool for at least
1
10 minutes.
Screw the old lamp out of the fitting
(see "Use").
Screw a bulb of the same type into the fitting.
When doing this, ensure that the lamp is se-
curely seated.
Maintenance and cleaning
CAUTION! RISK OF ELECTRIC SHOCK!
For electrical safety reasons, never clean the
lamp
with water or other fluids nor im-
1
merse it in water.
Do not use solvents such as petrol and the
like as they could damage the lamp.
Allow the lamp to cool for at least 10 minutes.
Use a dry, fluff-free cloth for cleaning.
Werbung
Kapitel
Inhaltsverzeichnis
