Nikon Lite Touch Zoom 100W Bedienungsanleitung Seite 41

When the battery is replaced or re-installed, the date and time you set may be reset.
*
Check them. (
A characteristic of electronic cameras
In certain cases, due to static electricity, the Lite Touch Zoom
100W/Lite Touch Zoom 100W QD microcomputer may turn the
camera off, even with fresh, properly installed batteries. For the
same reason, the film may not advance properly. In each of these
cases, to resume operation, simply turn the power off, then turn it
on again. Or, remove and reinstall the battery.
When the battery is removed, the date/time you set may be reset.
Check them after reinstalling the battery. (
Downloaded from www.Manualslib.com
Problem
a The battery is installed the wrong way round.
No indicator
Insert the battery with the + and – ends
appears even
positioned as marked inside the battery
when the camera
chamber.
is turned on.
a No battery or dead battery.
Install a new battery.
The numeral " "
a " " blinks.
does not appear
Remove the film and load it again.
even when film is
loaded.
a You are out of the remote control working range.
Operate the remote control in a range within
5m facing the camera.
a Three or more minutes have elapsed since you set
The shutter
the camera to Remote Control mode.
cannot be
Set the camera to the Remote Control mode
released using
again.
the remote
a The remote control is operated in backlit.
control.
Change the position of the remote control.
a The service life of the battery in the remote control
has lapsed (5 years).
Install a new battery.
p. 39)
manuals search engine
Check points and solution
*
*
Additional Information
Ref. page
14
14,15
16,17
37
37
37
38
p. 39)
En
41