Automatic Time Setting; Manual Time Setting - Bresser Meteo Temp Bedienungsanleitung

9 Automatic time setting

After the power supply was established, the clock will auto-
matically search for the radio signal. This will take approxim-
ately 3 to 8 minutes to finish this process.
If the radio signal is received correctly, the date and time
will be set automatically and the radio control signal icon
turns on.
If the clock fails to receive the time signal, go ahead with the
following steps:
1.
2.

10 Manual time setting

1.
2.
3.
4.
5.
6.
30 / 36
Press and hold the UP button for 2 seconds to re-initial-
ize RC signal receiving.
Is the device still not receiving the signal, the time must
be set manually.
Press and hold SET button for approx. 4 seconds to
change to time setting mode.
Digits to be set are flashing.
Press UP or DOWN button to change the value.
Press SET button to confirm and continue to the next
setting.
Settings order: Year > Month > Day > Month (M) and
Day (D) / Day (D) and Month) > 12/24-hour mode >
Hours > Minutes
Finally press the SET button to save the settings and
exit the setting mode.