Cleaning The Machine - Makita DUB184 Betriebsanleitung

OPERATION
Do not place the machine on the
CAUTION:
ground hile it is s itched on. Sand or dust may
enter f rom su c tion inlet an d c ause a mal f un c tion or
personal injury.
Hold the machine firmly with a hand and perform the
blowing operation by moving it around slowly. When
blowing around building, big stone or vehicle, direct the
nozzle away from them. When performing an operation
in a c orner, start f rom t h e c orner an d t h en mo v e to w i d e
area.
Fig.12
MAINTENANCE
Al ays be sure that the machine is
CAUTION:
s itched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the man-
ual, do not attempt to dismantle the machine. Instead, ask Makita Authorized Service Centers, always using Makita
repla c ement parts f or repairs.
State of abnormality
Motor d oes not run.
Motor stops running af ter a little use.
T h e mac h ine d oes not reac h th e
max imum speed .
Abnormal vibration:
stop the machine immediately
Motor cannot stop:
Remove the battery immediately
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery s charge level is low.
O v erh eating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
The drive system does not work
correctly.
Electric or electronic malfunction.
9 ENGLISH

Cleaning the machine

Clean the machine by wiping off dust with a dry cloth or
one dipped in soapy water and wrung out.
Fig.13
Never use gasoline, benzine, thinner,
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
R emo v e d ust or d irt f rom t h e su c tion inlet at t h e rear o f
t h e ma c h ine.
Fig.14: 1. S u c tion inlet
Storage
The hook hole on the bottom of the machine is conve-
nient f or h anging t h e ma c h ine f rom a nail or s c re w on
t h e w all. S tore t h e ma c h ine in a pla c e out o f t h e rea c h
o f c h il d ren an d not e x pose d to moisture or rain.
Fig.15: 1. H ole
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
S top using th e mac h ine to allow it to c ool d ow n.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Ask your local authorized service center for repair.
Remove the battery and ask your local authorized
serv ic e c enter f or repair.