Brief Description Of Mainboard; Interfaces And Connectors; Installing/Removing Or Replacing Processor (With Heat Sink) - Fujitsu Siemens Computers D2703 Bedienungsanleitung

Brief description of mainboard

Information about boards
Be sure to observe the following for boards with ESD:
• You must always discharge static build up (e.g. by touching a grounded object)
before working with the board.
• The equipment and tools you use must be free of static charge.
• Remove the power plug from the mains supply before inserting or removing
boards.
• Always hold boards by their edges.
• Never touch connector pins or conductors on the board.
An overview of the features is provided in the data sheet.
Special features
Your mainboard is available in different configuration levels. Depending on the configuration,
your mainboard will be equipped with or provide support for certain features.
This manual describes the most important properties of this mainboard.

Interfaces and connectors

The location of the interfaces and connectors of your mainboard is specified
at the beginning of the manual.
The components and connectors marked are not necessarily present on the mainboard.
Installing/removing or replacing processor
(with heat sink)
Disconnect the system from the mains voltage before performing any of the tasks
described below. Details are contained in the operating manual of your system.
Technical data
• D2703-S:
AMD Mobile Turion, AMD Mobile Sempron, max. 35 W in S1 design
• D2703-A:
AMD Mobile Sempron, max. 9 W in S1 design
• A current list of the processors supported by this mainboard is available on the
Internet at: "www.fujitsu-siemens.com/mainboards".
A26361-D2703-Z110-1-7419, edition 1
Brief description of mainboard
English - 1