Fort 300 W Bedienungs- Und Wartungsanleitungen Seite 72

Use and maintenance instructions: RECHARGE
5.2 TYRES PRESSURE
All tyres shall be inflated at a 2 bar pres-
sure.
- It is forbidden to move along yielding groun-
ds where the machine might tip over; in
reverse, move along slowly by paying atten-
fig. 7
tion not to stumble on obstacles: if this should
happen, immediately release the controls and
the machine stops automatically.
5.3 BRAKE MANUAL RELEASE
The machine is equipped with an electrical brake
that locks the wheels in case of parking or in case
of non use. one. In case it is necessary to release
the automatic safety system, for example due to
fig. 8
a sudden fault or battery discharge, it is possible
to disable the function momentarily in a very easy
way.
In order to momentarily release the brake, do as
follows:
1. Tighten the screw shown in figure 9 clockwise
until you hear a "clock" indicating the release of
the electrical brake (you may simply pull the
machine until the brake is released).
2. Move the machine manually where you intend
to position or repair it.
3. Unscrew the screw shown in the figure anti
clockwise until the brake is engaged.
Check the correct engagement of the brake by
pulling or pushing the machine: the wheels must
fig. 9
be locked.
72