Cleaning - Sonoro SO-210 Bedienungsanleitung

Malfunction
Alarm does not work
19

Cleaning

L NOTICE!
Material damage from improper cleaning!
Only clean the device from the outside using a
dry, soft cloth. Never use abrasive or solvent-
based cleaning agents as these may damage the
surface of the device.
96
Possible cause
Battery is empty
Malfunctions due to other radio
transmitters or devices
Alarm is not switched on
Alarm volume is set to minimum
Headphones are connected
Elimination
Replace the battery of your remote
control (see Ä Chapter 7.5 'Pre‐
paring the remote control'
on page 83).
Increase the distance between the
source of interference and the
radio. Plug the device into another
socket so that the source of inter-
ference and the radio are con-
nected to different branch currents.
Switch on the alarm (see
9.5 'Switching on/off the alarm
clock' on page 88).
Increase the volume (see
Ä Chapter 9.3 'Setting the alarm
volume' on page 88).
Pull the headphones out of the
jack.
Ä Chapter