Setting The Sleep Timer; Setting The Dimmer - Sonoro SO 110 Bedienungsanleitung

Setting the display language
Fig. 16: Setting the language
You can set the language for the menu and the play-
back display (Fig. 16). The following languages are
available:
n English
n German
Switching Demo Sound on/off
Fig. 17: Switching Demo Sound on/off
You can switch the Demo Sound function on or off
(Fig. 17).
Resetting the device to the factory settings
Fig. 18: Resetting to the factory settings
If necessary, you can reset all specified settings, such
as language and time formats and saved stations, to
the default factory settings (Fig. 18).
8.4

Setting the Sleep Timer

The Sleep Timer is an automatic power-off function
that switches the device to Standby mode after the
specified time has expired.
Setting the Sleep Timer
Fig. 19: Switching the Sleep Timer on/off
1. Hold down the [SLEEP] button on the top of the
device or the remote control.
ð The display shows the [SLEEP] symbol
(Fig. 19/1).
Switching off the Sleep Timer
2. To switch off the sleep timer, press the [SLEEP]
button again.
54
ð The display does not show a symbol.
i
If the device was switched off by the Sleep Timer,
it will start in the mode you were listening to last
when you turn it on again.
Setting the time interval for the Sleep Timer
Fig. 20: Setting the time interval for the Sleep Timer
1. Hold down the [SLEEP] button on the top of the
device or the remote control.
ð The display shows the Sleep Timer (Fig. 20)
and the [SLEEP] symbol flashes (Fig. 20/1).
2. Turn the click wheel to select the desired time
interval length (Fig. 20/2).
i
The maximum time interval is 120 minutes.
3. Press the click wheel to confirm the settings.
ð When the specified time expires, playback
gradually fades out.
8.5

Setting the dimmer

You can use the dimmer to adjust the display bright-
ness.
Fig. 21: Setting the dimmer
1. Press the [DIMMER] button on the top of the
device or the remote control for approx. 3 sec-
onds.
ð The display shows [Light HI] (Fig. 21/A).
2. Adjust the brightness level from 8–15 by turning
the click wheel.
3. Press the click wheel on the device or the [OK]
button on the remote control to confirm the set-
ting.
ð The display shows [Light LO] (Fig. 21/B).
© 2013