Fitting A Cellular Antenna; Inserting The Sim Card - Grundfos CIM 260 Montage- Und Betriebsanleitung

This device complies with Part 15 of the
FCC Rules and with RSS-Gen of
Innovation, Science & Economic
Development Canada.
Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications made to this
equipment not expressly approved by
Grundfos may void the FCC authorisation
to operate this equipment.

2.5 Fitting a cellular antenna

The antenna for the CIM 260 or CIM 280 must be
connected to the module to establish connection to
the cellular network.
External antenna
See fig. 3.
Connect the antenna cable to the SMA connection
(pos. 1) of the CIM 260 or CIM 280. The antenna
must be installed outside the control cabinet in a
position with good reception conditions. If required
by the telecom company, connect an additional
antenna.
2
Fitting an external cellular antenna
Fig. 3
Pos. Description
Primary SMA connection for the cellular
1 antenna.
This antenna must always be connected.
Secondary SMA connection for the cellular
2
antenna*
* Only use this antenna connection if required by
the telecom company.

2.6 Inserting the SIM card

Before inserting the SIM card into the CIM 260 or
CIM 280, remove the PIN code, or set it to "4321".
Procedure
1. Insert the SIM card into a mobile phone.
2. Remove the PIN code from the SIM card, or set it
to "4321". See the manual of the mobile phone.
3. Insert the SIM card into the CIM 260 or CIM 280.
See fig. 4.
For CIM 280, you must have a SIM card
subscription with international SMS
roaming activated.
The slanted edge of the SIM card must
point downwards. See fig. 4.
1
2
1
Inserting the SIM card
Fig. 4
Pos. Description
1 SIM card holder
2 SIM card
5