Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
60
5. The alarm time is stored. The symbol shows in the
display.
6. Then switch the unit to standby.
Proceed as described above to set the second alarm time.
Select the menu "Alarm 2 Setup" with the /
The activated alarm will be displayed in standby mode with
the symbol " " for the fi rst alarm and the symbol " " for
the second alarm.
Turn off the alarm signal
Hold the
button pressed to shut off the alarm signal. The
display shows "ALARM OFF".
Snooze
The automatically set alarm function can be switched off for
10 minutes with the MENU / INFO / SNOOZE button. The
display shows "
".
Deactivate alarm function
Proceed as described in the section "Setting the Alarm
Time" (step 1 to 4). Select the setting "Alarm: Alarm off".
Confi rm with the
/ ENTER button.
AUX-IN Socket
For connecting to external players, e.g. MP3 player, smart-
phone, tablet PC etc. (Cable not included)
1. Please connect the external device with a 3.5 mm stereo
jack plug to the AUX-IN socket.
2. Use the MODE button to select AUX mode.
3. Start the playback of your audio source. You will hear the
sound playback from the external device through the
loudspeakers. You can use the + / – control to adjust the
volume. The control buttons are not operational.
4. For the remaining procedure please see the operating
instructions of the external sound source.
NOTE:
Adjust the volume of the external device to a comfortable
level.
Cleaning and Maintenance
CAUTION:
Do not immerse the device in water.
• Always remove the mains plug before cleaning the
machine.
• Any marks on the surface can be wiped off with a slightly
damp cloth without any additives.
DAB+4158_IM
Troubleshooting
Problem
The unit
cannot be
buttons.
operated
No DAB Radio
reception
Problems with
DAB radio
reception
No sound
Poor sound
quality
Alarm function
does not
sound
No audio
signal during
bluetooth
connection.
Device can not
be connected.
Cause
Solution
The unit is
Disconnect the power
blocked and
supply for 5 seconds.
"hangs"
Then switch the
device on again.
Reset the device to
the factory defaults.
see "Settings menu"
Telescopic an-
Fully extend the
tenna incorrectly
telescopic antenna
aligned
and align it vertically.
No Digital Radio
can be received
in your area
Depending on
Switch to FM mode to
the location, you
receive these stations.
may not be able
If these stations are
to receive some
transmitted via VHF.
stations at all or
Find out more on the
with interference
internet site of the
in your region.
radio station.
see also note on
page 57
Volume is too
Increase the volume
low
Radio signal too
Try to adjust the
weak
antenna position.
Volume set too
Increase the volume
low
with the control (10).
The device is not
Ensure that there is a
registered with
connection. Register
the audio source.
the device with the
audio source again, if
necessary.
Volume too low.
Increase the volume
on the device.
Increase the volume
on the audio source.
Registration does
Check to see if the
not work.
audio source supports
the A2DP protocol.
Audio source is
Turn on the audio
shut off.
source.
Bluetooth is shut
Turn on the Bluetooth
off on the audio
function on the audio
source.
source.
Bluetooth version
Use a different play-
is not supported.
back device.
02.09.16
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
