Initial Setup - Ventus AOK-5005E Bedienungsanleitung

Initial setup

Follow the instructions in the order described and first put the batteries in the wireless sensor. This is the
only way for the weather station to function without any problems.
the device on.
Wireless sensor
1. Use a thin screwdriver to remove the battery compartment cover on the back of the wireless sensor.
2. Insert 2 AAA / 1.5 V batteries facing in the direction indicated on the bottom of the battery compartment.
Make sure that the poles of the batteries are correct (+/-). As soon as the wireless sensor is receiving power,
the red pilot light will light up and thus display that data is being transmitted to the base unit.
3. Put the battery compartment cover back in place and screw it into place.
- Do not use batteries that have a voltage that is too low (only 1.2 V instead of 1.5 V). This affects the
accuracy of the measurements, among other things.
- If possible, use alkaline batteries instead of zinc-carbon batteries. Alkaline batteries last longer,
particularly outside in low temperatures.
Base unit
You can operate the wireless weather station using the power adapter or with batteries. If the wireless
weather station is connected to a power socket, it will be operated using the power mains, even if there are
batteries in the device. Remove depleted batteries from the battery compartment, as they can leak.
A) Power mains operation
ATTENTION
Use only the power adapter included in the delivery for power mains operation.
1. Insert the power adapter included in the delivery into the base unit port.
2. Plug the power adapter into a socket that corresponds to the voltage listed in the Technical Data.
3. Wait several minutes. The base unit needs this time to collect all the weather data and to receive radio
signals from the time signal transmitter.
B) Battery operation
1. Remove the battery compartment cover.
2. Insert 3 AAA / 1.5 V batteries facing in the direction indicated on the bottom of the battery compartment.
Make sure that the poles of the batteries are correct (+/-).
3. Put the battery compartment cover back in place and close it.
4. Wait several minutes. The base unit needs this time to collect all the weather data and to receive radio
signals from the time signal transmitter.
Do not press any buttons while switching